Altera Cyclone III LS FPGA - Manual (Page 15)

Chapter 4: Development Board Setup 4–3
Factory Default Switch Settings
© October 2009 Altera Corporation Cyclone III LS FPGA Development Kit User Guide
3. Set the board jumpers to match Table 4–3 and Figure 4–1 .
f
For more information about the FPGA board settings, refer to the Cyclone III LS FPGA
Development Board Reference Manual .
Table 4–3. Jumper Settings
Board Reference Shunt Position
J11 pins 1-2 Installed
J11 pins 3-4 Not Installed
J11 pins 5-6 Not Installed
J12 Not Installed
J18 Not Installed