Altera Transceiver Signal Integrity - Manual (Page 19)

Chapter 4: Development Board Setup 4–3
Factory Default Switch Jumper Settings
February 2013 Altera Corporation Transceiver Signal Integrity Development Kit,
Stratix V GT Edition User Guide
2. Set DIP switch bank (SW3) to match Table 4–2 and Figure 4–1 .
3. Set DIP switch bank (SW7) to match Table 4–3 and Figure 4–1 .
3 SW2-3
Switch 3 has the following options:
■ Open = No function.
■ Close (ON) = No function.
Open
4 SW2-4
Switch 4 has the following options:
■ Open = No function.
■ Close (ON) = No function.
Open
Table 4–2. SW3 Dip Switch Settings
Switch
Board
Label
Function
Default
Position
1 SW3-1 VCC
Switch 1 has the following options:
■ ON = S5GT_VCC is enabled.
■ OFF = S5GT_VCC is disabled.
ON
2 SW3-2 VCCRT_GXB
Switch 2 has the following options:
■ ON = VCCRT_GXB is enabled.
■ OFF = VCCRT_GXB is disabled.
ON
3 SW3-3 VCCA_GXB
Switch 3 has the following options:
■ ON position = VCCA_GXB is enabled.
■ OFF position = VCCA_GXB is disabled.
OFF
4 SW3-4 1p5V
Switch 4 has the following options:
■ ON position = 1p5V is enabled.
■ OFF position = 1p5V is disabled.
ON
Table 4–3. SW7 DIP Switch Settings
Switch
Board
Label
Function
Default
Position
1 SW7-1 2p5V
Switch 1 has the following sequence enable
options:
■ ON position = 2p5V is enabled.
■ OFF position = 2p5V is disabled.
ON
2 SW7-2 VCCR_GTB
Switch 2 has the following sequence enable
options:
■ ON position = VCCR_GTB is enabled.
■ OFF position = VCCR_GTB is disabled.
ON
Table 4–1. SW2 DIP Switch Settings (Part 2 of 2)
Switch
Board
Label
Function
Default
Position