Altera Transceiver Signal Integrity - Manual (Page 21)

Chapter 4: Development Board Setup 4–5
Factory Default Switch Jumper Settings
February 2013 Altera Corporation Transceiver Signal Integrity Development Kit,
Stratix V GT Edition User Guide
6. Set DIP switch bank (SW6) to match Table 4–6 and Figure 4–1 .
7. Set DIP switch bank (S7) to match Table 4–7 and Figure 4–1 .
Table 4–6. SW6 DIP Switch Settings
Switch
Board
Label
Function
Default
Position
1 REFCLK_SEL_U32
Switch 1 has the following options:
■ OSC enables oscillator input.
■ SMA enables SMA input.
OSC
2 REFCLK_SEL_U33
Switch 2 has the following options:
■ OSC enables oscillator input.
■ SMA enables SMA input.
OSC
3 REFCLK_SEL_U34
Switch 3 has the following options:
■ OSC enables oscillator input.
■ SMA enables SMA input.
OSC
4 REFCLK_SEL_U35
Switch 4 has the following options:
■ OSC enables oscillator input.
■ SMA enables SMA input.
OSC
Table 4–7. S7 DIP Switch Settings
Switch
Board
Label
Function
Default
Position
1 MSEL0
Switch 1 has the following:
■ Closed = Logic 0.
■ Open = Logic 1.
Closed
2 MSEL1
Switch 2 has the following:
■ Closed = Logic 0.
■ Open = Logic 1.
Closed
3 MSEL2
Switch 3 has the following:
■ Closed = Logic 0.
■ Open = Logic 1.
Open
4 MSEL3
Switch 4 has the following:
■ Closed = Logic 0.
■ Open = Logic 1.
Closed
5 MSEL4
Switch 5 has the following:
■ Closed = Logic 0.
■ Open = Logic 1.
Open
6 MAX BYPASS
Switch 6 has the following:
■ Closed = Logic 0. Includes the MAX II device in
the JTAG chain.
■ Open = Logic 1. Removes the MAX II device in
the JTAG chain.
Closed