Altera Transceiver Signal Integrity - Manual (Page 22)

4–6 Chapter 4: Development Board Setup
Factory Default Switch Jumper Settings
Transceiver Signal Integrity Development Kit, February 2013 Altera Corporation
Stratix V GT Edition User Guide
8. Set jumper blocks (J26, J28) to match Table 4–8 and Figure 4–1 .
1
For more information about the FPGA board settings, refer to the Transceiver Signal
Integrity Development Kit, Stratix V GT Edition Reference Manual .
Table 4–8. Jumper Settings
Board Reference Description Shunt Position
J26 Fan select — Pins 1-2 select auto operation. Installed
J26 Fan select — Pins 2-3 select fan on. Not installed
J28 PGMSEL (logic 1) — Pins 1-2 select user-defined image. Not Installed
J28 PGMSEL (logic 0) — Pins 2-3 select factory image. Installed