TOYOTA 2010 Sienna - Manual (Page 77)

50
1-2. Opening, closing and locking the doors
■
The power back door can be operated when (vehicles with power back
door)
●
The engine switch is in the “ON” position and the shift lever is in P.
●
The back door is unlocked.
■
Jam protection function (vehicles with power back door)
●
If anything obstructs the power back door while it is closing or opening,
the back door will automatically operate in the opposite direction.
●
If the jam protection function operates during two consecutive closing
operations, the back door will be stopped at that position.
■
Back door closer (if equipped)
In the event that the back door is left slightly open, the back door closer will
automatically close it to the fully closed position.
■
Assist operation (vehicles with power back door)
If the back door is closed approximately 4 - 6 in. (10 - 15 cm) from its fully-
opened position with the power back door main switch on, the back door
closer will automatically close it to the fully closed position. If the door is
closed slowly, assist operation may not be performed.
■
When the battery is disconnected
●
The back door will be automatically locked after the battery is recon-
nected.
●
The power back door (if equipped) must be initialized in order to ensure
proper operation.
Unlock the back door with the wireless remote control or door lock
switch.
Close the back door completely by hand.
STEP 1
STEP 2