Pengo RevTrak - Manual (Page 22)

22 PENGO RevTrak Manual
DATA EXPORT (DOwNLOAD)
7. Open the “Removable Disk” drive and two files
should be listed:
CONFIG.CFG and Torque.csv
The Torque.csv file contains the installation data.
This file can now be downloaded to a computer. See
figure 4E. The CONFIG.CFG file does not need to be
downloaded. The CONFIG.CFG file must remain on
the SD card for future recordings.
Note: Microsoft Excel is required to open and format
the raw data recorded by RevTrak.
8. When the Torque.csv file is opened in Microsoft
Excel a worksheet will appear with the raw installation
data. It is recommended that the file be saved and
named by date or by the job number, so the file name
Torque is not used. This will prevent data from being
copied over or lost.
Model ID
The model selected will be shown with a numeric
designation. Pengo Revolution Series models will be
represented by a number. See Model Number Key.
REvTRAK OPERATION
OPERATING PROCEDURES CONT.
Figure 4E
DRIvE MODEL NUMBER KEY
The Drive model will be represented by a number when the
raw data is exported into Excel. Below is the model key:
0 - DS-2
1 - DS-3
2 - DT-5
3 - DT-15
4 - RS-7 / 7X
5 - RS-12
6 - RT-9
7 - RT-12
8 - RT-20
9 - RT-30
10- RT-40
11 - Rv-70
12 - Rv-100
13 - Rv-140
14 - Rv-200
15 - CUSTOM 1
16 - CUSTOM 2
CONFIG.CFG
This file is to remain on the SD
card permanently. Logger will
not recognise SD card without
this file.
Torque.csv
This file is the data recorded by the RevTrak. Each
time the data is downloaded the file name will be
“Torque.csv”
It is highly recommended that the file be saved and
named by date or by the job number, so that the file
name “Torque” is not used. This will prevent data
from being copied over or lost.