TEKVOX 51T-HD Presentation Switcher - Manual (Page 13)

TEK 51T-HD Compact Presentation Switcher
TEKVOX, INC. 9 www.tekvox.com
connects to ground.
3.5 Application
The TEK 51T-HD is ideal for smaller system applications especially when there is no
need for an equipment rack. The switcher can be mounted under a conference table, on
a wall,
or in a teacher’s desk. When used with a TEKVOX Drop-In system, a low cost
and complete mediated classroom system can be created.
4. System Operations
4.1 Operations of Buttons
The buttons are used for output resolution adjusting, switching operations, Firmware
updating, volume adjusting and operations in menus.
Resolution Adjusting 4.1.1
Resolution can supports both auto and manual settings. Press and hold the
RESO/AUTO button for 7 seconds or more to enter into
auto-adjusting/manual-adjusting mode.
Notice:
1. In auto-adjusting mode the TEK 51T-HD uses the EDID of the display to set the
resolution.
If you need to set the resolution of local HDMI display device:
 Power off the TEK 51T-HD and break the connection between the TEK 51T-HD and
TEK TPHD402PR.
 Turn on the power for the TEK 51T-HD.
 Get the resolution of local HDMI output device.
 Connect the TEK TPHD402PR to TEK 51T-HD.
2. In auto-switching mode front panel button control is not available, but IR and RS232
control is able to switch modes.