Adtec digital mediaHUB-HD 422 (version 1.01.10_M_2) Manual - Manual (Page 35)

Connecting to the mediaHUB HD 422
Using Telnet (standard 23 port)
To connect to your mediaHUB-HD 422 using a terminal session you will need to set the IP address of the unit. See earlier
instructions on setting the IP via the front panel.
Using a terminal window, complete the following:
Step Action
1 Type 'telnet x.x.x.x' in a terminal window, without quotes, where x.x.x.x is the IP address of the unit.
2 Press <Enter>.
3 When prompted for a username, enter adtec.
4 When prompted for a password, enter none.
Once you see User adtec connected, the session is open and you may issue API commands to the unit.
For the mediaHUB-HD 422 there are specific commands for the encoder as well as specific commands for the decoder. Each
has a unique way of accepting commands. If using telnet is your preferred method of communication to the mediaHUB-HD
422, familiarize yourself with the API commands and their respective command handlers. For more information on this, point
your browser to the IPA of your unit and look through the api notes that are described for the mediaHUB-HD 422.
FTP connections can be made to the Adtec device using any ftp client.
Host: <ipa of the unit>
Default Username: adtec
Default Password: none
Port: 21
www.adtecdigital.com