Adtec digital mediaHUB-HD 422 (version 1.01.10_M_2) Manual - Manual (Page 84)

Manual Upgrade Procedures
You can upgrade your Adtec device's firmware via built-in web-based application, described in the Upgrade Tab section, or via
a Telnet/FTP session, described in this article.
To update your device's firmware via a Telnet session, perform the following:
Step Action
1 Obtain the desired firmware version file from adtecftp.com
2 Using any FTP client upload the firmware file to the device
3 Open a Telnet session and enter the IP address of the unit you are going to update.
4 Enter the username as ' adtec ' and the password as ' none '.
5 Enter the following in sequence: * ST
6 * version search - from the results, look for the pathname of recently uploaded firmware file
7 * version install [pathname of the .tgz file]
Manual Upgrade 'Step by Step'
Step Action
1
Obtain the desired firmware version file from www.adtecftp.com
note*: Firmware releases are found in the Public Folders -> Firmware -> Release -> section of the website in a folder
with the product name. username: adtecftp password: adtecftp2231
note**: Windows Internet Explorer renames adtec firmware file extensions to .gz . When saving please add a t within
the extension to read .tgz if IE has renamed your file.
2
Use your favorite FTP client to upload the firmware file to the device.
If you are unfamiliar with FTP you may use a 'My Computer' window and type in the address bar,
ftp://adtec:[email protected] where 192.168.10.48 should be replaced with the IP Address of YOUR device. You
may then drag and drop the firmware file into the hd0 folder.
3
Open a Telnet session and enter the IP address of the unit you are going to update.
note*: If you are unfamiliar with telnet, open a command prompt window (windows: start -> run.., mac: macintosh hd
-> applications -> utilities -> terminal) and type: telnet 192.168.10.48
4 Enter the username as ' adtec ' and the password as ' none '.
5 Enter the following in sequence: *.ecmd stop
6 *.sysd vrn search - from the results, look for the pathname of recently uploaded firmware file
7 *.sysd vrn install [pathname of the .tgz file]
www.adtecdigital.com