Argox X Series - Manual (Page 31)

31
Adjust Position of Label Sensor
Function of the label sensor is to detect the gap, notch, or holes of
labels, to help the printer for accurate print positions and label
length. For labels with gaps, label sensor can be positioned
wherever media locates. If labels with notches or holes are in use,
follow the steps below to check position of the label sensor:
-
Unlatch the Print head Latch. (as Figure 2 in Section
–
Standard Mode Loading Media)
- Pull down Paper Sensor Position Lever (as Figure 3 in
Section
– Standard Mode Loading Media), to horizontally
adjust position of label sensor.
- Make sure the Media sensor position mark locates right on
notch or hole of labels.
Check below.