Argox X Series - Manual (Page 74)

74
graphics or forms. Check data format. Call
for service.
SENSOR O.R. READY Media calibration is out of range for sensor
detection. Make sure media is loaded and
media sensor locates under media.
PRINT HEAD
HEAT MEDIA Printing job will start until the temperature
of TPH goes down.
HEAD OPEN READY Print head latch is not closed. To print label
the head latch must be closed.
Transmission Problems
If the host shows "Printer Time out"
1. Check if the communication cable (parallel or serial) is
connected securely to your parallel or serial port on the PC
and to the connector on the printer at the other end.
2. Check if the printer power is turned on.
If the data has been sent, but there is no output from the printer.
Check the active printer driver, and see if Seagull Driver for your
Windows system and the label printer has been selected.
Recovery
After correcting problems, simply press the CANCEL button or
restart the printer. Make sure the LEDs are not blinking and
remember to resend your files.