Audio Enhancement TLD100 - Manual (Page 15)

15
F1 CNT, F2 CNT function
These functions are available when MTD-09 is used. When F1 or F2 signal is transmitted from the microphone, it will
active F1 CNT or F2 CNT terminal on the receiver. Selection between F1 and F2 is made at the microphone side.
Function 1 (F1): Default setting is Open.
Press the function button [F] of the microphone to select the closed state of 300 ms.
Function 2 (F2): Default setting is Open.
Press the function button [F] of the microphone for 2 seconds or more to select the closed state.
Note:
• To stop the microphone from transmitting the F2 signal, it must be turned off. Then turn off the IR-Satellite Sensor/
Receiver (this unit) to reset it.
If the IR-Satellite Sensor/Receiver (this unit) is not turned off, the F2 terminal will be open (reset) 3 minutes after not
receiving a signal from the microphone.
F1 CNT
(Holding
down)
Microphone
300 ms 300 ms 300 ms
600 ms 600 ms 600 ms
300 ms
3 LEDs flash
in blue.
F2 terminal will be closed when
3 commands are sent within 5
seconds after the first F2
command.
Commands are
sent periodically
from the
microphone while
holding down the
function button
[F].
F1
F2 CNT
Open
Closed
Microphone
5 s timer/ch
3 minutes timer
2 s 1 s 1 s 1 s 1 s
Last F2 command
Timer restarts.
F2
TLD100
F2
terminal
Open
Closed
TLD100
F1
terminal
Open
Closed
TLD100
F1
terminal
F1 CNT
(Press)
Microphone
300 ms
3 LEDs flash
in blue.
Default setting:
Open
Default setting:
Open
Default setting:
Open
Flash!
F1
Type Actions
Commands are sent
periodically from the
microphone until the
power is turned off.
3 minutes from the
last F2 command
1st 2nd 3rd
ON
OFF
or
Hidden
Flash!
Flash!
Flash!
Flash! Flash!
3 LEDs
light
in blue.
Holding down