Audio Enhancement TLD100 - Manual (Page 18)

18
•
Channel setting
Refer to the combination table and set each channel appropriately.
This unit can receive only through CH1 and CH2. Therefore, this unit cannot receive by selecting CH3 or CH4 with the
microphone or sensor (EDS-07).
Infrared wireless microphone
Channel switch [1, 2, 3, 4]
Coverage frequency TLD100 EDS-07
(System expansion)
1 2.30 MHz Available Channel settings [1/2]
2 2.80 MHz Available
3 3.20 MHz Not available Channel settings [3/4]
(Cannot be set)
4 3.80 MHz Not available
Transmission channel setting for the infrared
wireless microphones
Remove the battery cover of the microphone ( ①) and set
the transmission channel ( ②).
Refer to the above combination table and set the channel
correctly.
• Do not assign the same channel to two or more micro-
phones in a space.
• The power indicator blinks if channel is set to any
unspecified position except 1 to 4.
• Please note that the TLD00 will only receive
Channels 1 and 2.
•
Sensor setting
For TLD100:
No setting is necessary. CH1 and CH2 are fixed for
reception channels.
For EDS-07:
Switch the channel select switch to select [1/2].
Refer to the above combination table and set channel
correctly.
1
1
2
2
3
3
4
4
CH
CH
4 3 2 1
① ①
②
MHH-09 MTD-09
②
CH 2 1
1 2
3
3 4
F 1
4
F 2
① Battery cover
② Channel select switch (inside the battery cover)
Channel select switch (1/2)
TLD100
EDS-07