Audio Enhancement TLD100 - Manual (Page 34)

34
Specifications
General
Power (DC IN) 24 V DC (use the specified AC adaptor (included))
Input current 160 mA (At 4 pieces of extended sensors (EDS-07) connected)
Operating temperature range 0 °C - 40 °C {32 °F - 104 °F}
Dimensions Sensor/receiver: ø152 mm x 76 mm (H) {ø6 inches x 3 inches (H)}
* Excluding F-type connector
Conversion box: 25.5 mm (H) x 67 mm (W) x 67 mm (D)
{1 inch (H) x 2-5/8 inches (W) x 2-5/8 inches (D)}
* Excluding screw hole
Mass Sensor/receiver: Approx. 500 g {1.1 lbs}
Conversion box: Approx. 80 g {0.18 lbs}
Finish Sensor/receiver: Infrared passing-type acrylic resin (black color)
ABS resin white color
Conversion box: ABS resin black color
IR receiver
Reception channel
(subcarrier frequency) CH1: 2.3 MHz, CH2: 2.8 MHz
Reception system T.R.F. (Tuned Radio Frequency)
Receiving sensitivity S/N 60 dB or more (40 dBµV input, ±12.5 kHz FM @1 kHz)
Signal-to-noise ratio 70 dB or more (60 dBµV input, ±12.5 kHz FM @1 kHz)
Audio
General
Signal-to-noise ratio 70 dB or more (Line in to Mixing output)
Frequency response 50 Hz – 15 kHz (Line in to Mixing output)
100 Hz – 10 kHz (Microphone to Mixing output)
Total harmonic distortion 0.5 % or less @1 kHz (Line in to Mix
1.0 % or less (Microphone to Mixing output, 60 dBµV input, ± 12.5 kHz FM @1 kHz) ing output)
LINE IN L/R –10 dBV input impedance 10 kΩ or more Unbalanced, stereo (monaural mixing),
ø3.5 mm (ø1/8 inches) stereo mini jack (Tip: Left, Ring: Right, Sleeve: GND)
CH1/CH2 (Microphone output) –5 dBV Balanced, Adaptive impedance 10 kΩ or more,
ø3.5 mm (ø1/8 inches) stereo mini jack (Tip: Hot, Ring: Cold, Sleeve: GND)
MIX OUT 0 dBV Balanced, Adaptive impedance 10 kΩ or more,
ø3.5 mm (ø1/8 inches) stereo mini jack (Tip: Hot, Ring: Cold, Sleeve: GND)
Control terminal
F1 CNT, Com Output format: open collector, make output
Electrical specifications: control voltage; 30 V, control current; 20 mA
F2 CNT, Com
F2 ACK, GND Input format: transistor input
Electrical specifications: open voltage; 5 V DC, short-circuit current; 2 mA
PAGE MUTE, GND
RS-232C TxD Compliant with RS-232C, asynchronous, 9600 bps
RxD
SG