Audio Enhancement TLD100 - Manual (Page 9)

9
Major operating controls and their functions (Conversion box)
① Receiver connector [TO RECEIVER]
This connector, labeled “TO RECEIVER”, is used to
connect a cable to the sensor/receiver.
② DC power connector [DC IN]
This connector is used to connect the supplied AC
adaptor. No switch is equipped in this unit. This unit
operates immediately after connecting the AC adaptor
to this connector.
③ Microphone CH1 output connector [CH1]
④ Microphone CH2 output connector [CH2]
⑤ Mixing output connector [MIX OUT]
This connector provides the audio output of LINE IN of
the main unit. Setting the No. 4 of the DIP switch to
ON allows the audio outputs of the microphone CH1
and CH2 received by this unit to be provided after
mixing with LINE IN.
Tip (+), Ring (-), Sleeve (ground).
This is a TRS balanced output:
⑥ Cable binding hook
This hook is used to hold cables with a cable tying
band or the like.
① ② ③ ④ ⑤ ⑥
⑨ DIP Switch
This switch can select the operation mode of each
function equipped in this unit (see page 17).
The settings of this switch are updated at the time of
turning on the power. Settings changed while powered
up are not updated until the power is turned off and
then back on (excluding DIP Switches No. 7 and 8).
This connector provides the audio output of
microphone CH1 received by this unit. This is
a TRS balanced output.
This connector provides the audio output of
microphone CH2 received by this unit. This is
a TRS balanced output.