Remote link ii technical guide, Prism ii setup for alarm call-outs – Auto-Zone Control Systems Remote Link II Technical Guide, Installation Instructions for the Remote Link II Modem (Version 01C) User Manual
Page 15
Remote Link II Technical Guide
15
Operator Interface
Prism and Prism II Setup Instructions for Alarm Call-Outs
Prism Setup for Alarm Call-Outs
1.
Open your Prism software. Click on the
<Key>
button and type in your level 3
passcode (default “sm”). Click
<Done>
.
2. If Prism is offl ine, click
<Communications>
and
then click
<Go Online>
.
3. Click
<Communications>
and then click
<Setup CommLink>
.
4. The
CommLink Setup Window will appear. Click
<Load Settings>
. Type in the number of the
receiving cell phone in the pager fi eld.
Click
<Save Settings>
and
then click
<Done>
.
5. In your cell phone entries, create an entry for each of
your job sites with its corresponding phone number so
that you know which job site has an alarm.
Prism II Setup for Alarm Call-Outs
1.
Open your Prism II software. Click on the
<Keys>
button and type in your level 3
passcode (default “9288”). Click
<OK>
.
2. Click
<Communications>
and then click
<Setup CommLink>
.
3. The
CommLink Settings Window will appear. Click
<Load>
. Type in the number of the receiving cell
phone in the cell/pager fi eld. Click
<Save>
and
then click
<Exit>
.
4. In your cell phone entries, create an entry for each of
your job sites with its corresponding phone number so
that you know which job site has an alarm.