Auto-Zone Control Systems Remote Link II Technical Guide, Installation Instructions for the Remote Link II Modem (Version 01C) - Manual (Page 6)

Remote Link II Technical Guide
6 Operator Interface
USB Driver Installation Instructions For Windows
®
XP
8. Highlight the Win98_Win_2000_Win98 directory by
clicking on it and then click <OK> .
9. The screen will now state, “Please wait while the
wizard installs the software...”
10. While the fi les are downloading, a Hardware
Installation Window might pop up as shown below.
Click
<Continue Anyway> .
11. The wizard will then fi nish installing the software.
12. Once the wizard is done, click <Finish> .
USB Serial Port Driver Installation for
Windows
®
XP
1. Once the USB Serial Converter software is installed,
the Found New Hardware Wizard will appear again to
download the USB Serial Port software.
2. Follow steps 1 though 7 of the previously described
USB Serial Converter Driver Installation instructions.
3. Click <Finish> when the wizard is done download-
ing the software.
4. Windows ® XP requires you to restart your computer
before the new settings will take effect.
5. Continue with the next section “Disabling the Analog
Modem Driver Installation in Windows ® XP” on
page 8.
Revised 6/14/11