Auto-Zone Control Systems SS0070 USB-Link Technical Guide, Installation Instructions for the SS0070 USB-Link (Version 01D) - Manual (Page 14)

USB-Link Technical Guide
14 Operator Interface
Troubleshooting the USB Drivers for
Windows
®
XP
If the Found New Hardware Window did not appear when you plugged
in your USB-Link or if you canceled out of the installation procedure
for any reason, you will have to follow these instructions to install the
USB drivers.
1. Plug the USB cable attached to the USB-Link into your
computer’s USB port.
2. Click <Start> , click <Control Panel> , and then double-
click
<System> . The System Properties Window will
appear. Click the <Hardware> tab and then click
<Device Manager> .
3. The Device Manager Window will appear. In this window,
look for an exclamation point in the categories, “Other
devices,” “Ports,” or “Universal Serial Bus controllers.”
Click the item containing the exclamation point.
Troubleshooting the USB Drivers for Windows
®
XP
4. Right-click on USB Serial Port and then click <Update
Driver> . The Hardware Update Window will appear.
5. In response to the question, “Can Windows search for
software?” click the radio button, “No, not at this time”
and then click
<Next> . Insert your USB Drivers CD-ROM
into your CD-ROM drive. And then click the radio button,
“Install from a list or specifi c location” and click
<Next> .
6. The screen will now display the message, “Search for driver
software in this location:” If the location is correct, click
<Next> and go to step 8. If not, click <Browse> .
7. Select the CD-ROM location from the list of folders and
then click <OK> .
8. A message will appear that states, “Please wait while the
wizard installs the software...”
9. When the installation is complete, the window below will
appear. Click <Finish> .