Auto-Zone Control Systems SS0070 USB-Link Technical Guide, Installation Instructions for the SS0070 USB-Link (Version 01D) - Manual (Page 8)

USB-Link Technical Guide
8 Operator Interface
USB Serial Converter and Serial Port
Driver Installation for Windows
Vista & 7
1. Insert the USB Drivers CD-ROM into your CD-ROM
drive or download the USB Drivers fi le from www.orion-
controls.com/software-new.html. If using the CD-ROM, go
to Step 2. If downloading the fi le, click on the USB Driver
Setup.zip fi le to unzip the fi le and then go to Step 3.
2. Double-click on the Vista/Win_7 folder.
Double-click on USB Driver Setup.exe.
3. The WattMaster USB Driver Installation Window will
appear.
4. If you wish to change the Destination Folder, click
<Browse> and change the location. Click <Install> to
install the software. Then, open the WattMaster USB Driver
folder in the temp directory on your hard drive or the new
location if you changed the destination folder.
5. Double-click USBInstaller.exe.
6. Then click the <Begin Install> button.
7. The installation program will walk you through the rest of
the steps. The program might prompt you to remove old
USB drivers from your computer. Click
<Yes> if so. Once
installation is complete, you will need to reboot your com-
puter to have the new settings take effect.
8. With successful USB driver installation, you can now con-
nect your USB device.
9. Follow the procedures on page 9 to verify the Comm Port.
USB Driver Installation For Windows Vista & 7
Revised 6/14/11