Auto-Zone Control Systems SS0070 USB-Link Technical Guide, Installation Instructions for the SS0070 USB-Link (Version 01D) - Manual (Page 16)

USB-Link Technical Guide
16 Operator Interface
Troubleshooting EPROM Software
Verifying CommLink II, CommLink III,
and MiniLink EPROM Software Versions
In order to view controllers with the USB-Link on a networked sys-
tem, the CommLink II and III must have version 3.15 software or later
installed and the MiniLink must have version 3.14 software or later
installed. Please follow the directions to determine the current software
version.
NOTE:
If you purchased your CommLink II, III, or MiniLink
after January 1, 2007, there is no reason to check the
software version nor is it necessary to check the soft-
ware version of a CommLink IV.