Avalon Firestyles DVL Fireplace EF-2003 to 2007 - Manual (Page 7)

Installation
(for qualified installers only)
7
Travis Industries 4041206 1 0 0 - 0 1 1 4 7
Installation Warnings:
• Failure to follow all of the requirements may result in property damage, bodily
injury, or even death.
• This heater must be installed by a qualified installer who has gone through a
training program for the installation of direct vent gas appliances.
• This appliance must be installed in accordance with all local codes, if any; if not,
follow ANSI Z223.1 and NFPA 54(88).
• In Manufactured or Mobile Homes must conform with Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280, or, when such a
standard is not applicable, the Standard for Manufactured Home Installations,
ANSI/NCSBCS A225.1. This appliance may be installed in Manufactured Housing
only after the home is site located.
• The fireplace is designed to operate on natural gas, or propane (LP).
• All exhaust gases must be vented outside the structure of the living-area.
Combustion air is drawn from outside the living-area structure.
• Notify your insurance company before hooking up this fireplace.
• The requirements listed below are divided into sections. All requirements must be
met simultaneously. The order of installation is not rigid – the qualified installer
should follow the procedure best suited for the installation.
Packing List
• Propane Conversion Kit
• Log Set
• Glass Latch Key (to un-latch glass frame)
• Firestop
• Fireback Clips (for Ceramic Firebacks Only)
Additional Items Required
• Faceplate
• Direct Vent (Simpson Dura-Vent Ph. # 800 835-4429)
• Gas Line Equipment (shutoff valve, pipe, etc.)
• Electrical Equipment (min. 14 gauge, grounded line)
Installation Overview
Non-combustible facing
(see the section "Facing
Requirements")
See the section
"Acceptable Vent
Lengths"
See the section "Horizontal
Termination Requirements"
See the section
"Gas Line Installation"
See the section
"Electrical Connection"
See the section
"Mantel Requirements"
Insulation must not fill
the 1" clearance
around the back and
sides of the fireplace.
See the section "Fireplace
Placement Requirements"
6" Min.
See the section
"Vent Requirements"
See the section "Minimum
Framing Dimensions"
See the section
"Hearth Requirements"
Drywall
Nail
Down
Plate This grommet and hole is for
thermostat wire (on both sides)
Side
Wall