Avery Dennison 6035 Programmer Manual Rev.CA 6/01 User Manual
Page 179
5-20 Programmer’s Manual
Field
Description
uchContinuousMode
Enable/disable continuous mode
scanning. If uchContinuousMode is
enabled and uchLowPower is enabled,
the scanner goes into low power mode
between scans.
Default: SCN_DISABLE
uchMsiCheckDigits
The number of MSI check digits (either
1 or 2).
Default: 1
uchCode128FunctChars
Enable/disable transmission of Code
128 function characters. This
parameter and uchUPCEAN cannot
both be enabled.
Default: SCN_DISABLE
uchUPCEANAuto
Enable/disable the ability to distinguish
UPC/EAN (+2, +5) bar codes from each
other.
Default: SCN_ENABLE
uchLowPower
Enables low power mode. If
uchContinuousMode is enabled and
uchLowPower is enabled, the scanner
goes into low power mode between
scans. You should leave this option
enabled.
Default: SCN_ENABLE
uchTimeOut
Scanner time-out value in seconds.
Values are 1-4.
Default: 3
uchMSICDMod11
The MSI check digit scheme. Values
are 0 (Modulo 10/Modulo 10) and 1
(Modulo 11/Modulo 10).
Default: 0
uchUPCECD
Enable/disable the return of UPCE
check digits with scanned data.
Default: SCN_ENABLE