Avery Dennison 6035 Programmer Manual Rev.CA 6/01 - Manual (Page 79)

4-38 Programmer’s Manual
p c l P a p e r S e t u p
Description
Gives information about the supplies being used to the Print
subsystem.
If you are using paper or synthetic supplies, precede this
function with a call to pclCalibratePaper.
If an application uses this function and
pclCalibratePaper, it should not use
pclCalibrate.
Syntax
unsigned short far pclPaperSetup(unsigned short usStockLength,
unsigned short usStockWidth,
unsigned short usStockType);
Parameters
usStockLength The supply length in hundredths of an inch.
Values are 55-400.
usStockWidth The supply width in hundredths of an inch.
Values are 120, 150, and 200.
usStockType The supply type. Values are
MMS_LOW_ENERGY Paper
MMS_MEDIUM_ENERGY Fax
MMS_HIGH_ENERGY
Synthetic
If you are using linerless supplies, experiment
with these values to see which one achieves the
best results.