Baby Lock Imagine Wave (Previous Model) (BLE3ATW) Instruction and Reference Guide - Manual (Page 13)

1. With the presser foot up and machine lock button in the locked position, see fig. A, page 10, set the thread-
ing port selector lever to "U" for upper looper threading. See fig. B, page 10.
2. Place the thread on the Upper Looper spool pin on the thread stand. Slip the thread into the telescopic
antenna thread guide "A" directly above the spool, snap into the thread guide "B", at the top of the front
cover, through the slot on the front cover. See fig. C, below.
3. Pull 18 inches (40cm) of thread through guide "C". Insert the end of the thread into the threading port "U",
about 1 inch (2.5cm). Use tweezers, if necessary, to insert the thread end more easily. See fig. D below.
4. Depress the threading lever (fig. D below) . If the thread does not go through the upper looper eye with
one push, depress the threading lever again until it does, and leave thread hanging loose.
5. Move the lock button release lever to the right.
*Be sure at least 1" of thread is inserted into the threading port.
S
E
R
G
E
R
S
E
T
U
P
11
Upper Looper
Looper Threader Lever
D
C
2
2
3
B
B
A
1
C
1"
(2.5cm)
18"(40cm
)