Baby Lock Imagine Wave (Previous Model) (BLE3ATW) Instruction and Reference Guide - Manual (Page 15)

1. Set the needle threader selector on "L" for left needle.
2. Place the thread on the far-left spindle on the thread stand (fig.A page 12).
Thread needle thread guides A and B, through the groove on the face place and through guides
C,D,E,F and G.
3. Lower the presser foot and thread the left needles as in steps 4 and 5, under "Right Needle."
1. Set the needle selector on "R" (right needle) or "L" (left needle).
2. Press the needle threader lever down (Fig. B) so that the hook goes into the eye of the needle.
The hook will remain in the eye of the needle until you press the needle threader lever down
again to release it.
3. Hold the needle thread horizontally with both hands and place the thread under the threader
hook guides. (Fig.C)
4. Press the needle threader lever down again. (Fig.D) The hook will pull the thread through the
eye of the needle as it is released.
NOTE: The machine in Locked Position also sets the needle position for using the Needle
threader.
This is also a safety feature when threading as the machine cannot sew while in locked position.
S
E
R
G
E
R
S
E
T
U
P
13
Left Needle
Looper Thread Fine-Tuning Screw
No adjustments are needed when sewing with most fabrics and
threads on your Baby Lock Imagine Wave, but certain threads or
fabrics may require minor fine-tuning of the looper delivery system
to perfect your stitches. Increase or decrease the delivery of the
looper threads with the upper and lower looper thread fine-tuning
screw. With a screwdriver (found in accessory kit), turn the fine-tun-
ing screw clockwise to tighten the looper threads. Turn the screw
counter-clockwise to loosen the looper threads.
Ideal Stitch
Looper threads are
too loose.
Looper threads are
too tight.
Standard Position Tighten the screw ( + ) Loosen the screw ( - )
Needle Threader
Needle
Threader
Selector
Needle
threader Lever
B C D