Baby Lock Imagine Wave (Previous Model) (BLE3ATW) Instruction and Reference Guide - Manual (Page 37)

W
A
V
E
S
T
I
T
C
H
35
3-Thread Rolled Wave Stitch
NEEDLES
right
LENGTH
1.0-1.5R
WIDTH
3.0-5.5
STITCH
SELECTOR
C
WAVE
SELECTOR
A
B
C
D
B
C
D
W
W
A
W
1. Turn the Wave Selector dial from "O" to "W".
2. Cut the threads from the thread cones and remove from the thread paths.
3. Lock the machine for threading the loopers. (see page 10)
4. Place the right needle thread cone on the far left spool pin.
5. Slip the right needle thread into the telescopic thread guide directly above the thread. Follow the left
needle threading path down to the right needle.
6. Thread the right needle using the needle threader set on "R". (see page 13)
7. Place the upper looper thread cone on the 2nd from left spool pin.
8. Slip the upper looper thread into the telescopic thread guide directly above the thread. Follow the top
threading path for the right needle thread, down the front threading path, to the left of the chrome thread
guide, and directly to the "U" jet air threading port for the upper looper. Set the Looper Threader
Selector on "U". Thread the upper looper. (see page 11)
9. Place the right needle thread and upper looper thread under the presser foot and to the back.
10.Place the lower looper thread cone on the 3rd from left spool pin.
11. Slip the lower looper thread into the telescopic thread guide directly above the thread, then slip the
thread into the lower looper telescopic thread guide to avoid the thread getting tangled while sewing.
Take the thread through the standard lower looper threading path to the "L" jet air threading port for the
lower looper. Set the Looper Threader Selector on "L". Thread the lower looper. (see page 10)
12. Set Stitch Selector on "C" for Rolled Wave Stitch.
13.Set Stitch Length and Stitch Width follwing the illustration below.