Baumatic BFWM1407W.1 - Manual (Page 33)

33
 The moulded plug that is supplied with the appliance must be
placed into an earthed and insulated socket.
 Broken or damaged power leads must only be replaced by a
suitably qualified person. A power lead of a similar type must be
used in replacement.
 IMPORTANT: We do not recommend that this appliance is
connected to an extension lead.
Before first use maintenance wash
o
When your washing machine has been correctly installed, we
recommend that you perform a high temperature wash cycle,
without any clothing being placed inside of the drum.
o
This will check that all aspects of the installation are correct;
it will also remove any deposits that may have been left on
the drum by the manufacturing process.
Error code failure system
If your appliance senses that it is not operating correctly, then an error
code may appear on the LED display.
The following error codes can possibly be remedied by the customer
and the steps outlined below should be followed.
BEFORE COMPLETING ANY MAINTAINEANCE ON THE
APPLIANCE, IT SHOULD BE DISCONNECTED FROM YOUR
POWER SUPPLY.
Error
code
Reason Solutions
Inlet water
overtime.
o
Open the water tap to check if the inlet
hose is squashed or kinked.
o
Check if the filter in the inlet valve is
blocked or not.
o
Check if the water pressure is too low.
Overtime of the
drainage.
o
Check if the drain pump is blocked (see
relevant section).
The door has not
been closed.
o
Check if the door of the washing machine
is closed.
o
Check if the clothes are preventing the
door from closing properly.
Other
o
Contact the Customer Care Department.