Beurer PM 62 - Manual (Page 17)

16
contact points on the inside of the chest strap. For this, lift the
chest strap up from the skin slightly and wet the two sensors with
a little saliva or water or a conductive gel.
The contact between the skin and chest strap may not be inter-
rupted also with greater movements of the thorax such as during
deep breathing. Significant chest hair can interfere with and even
prevent contact.
„ Put on the chest strap a few minutes before starting in order to
warm it up to body temperature and establish optimal contact.
6.5 Water Resistance
NOTICE:
„ Do not jump into water (high pressure load) and press but-
tons in the rain or while in water. This might impair the im-
permeability of the monitor to moisture and therefore dam-
age the unit.
The PM62 is suitable for bathing and swimming.
Water Resistance = 98 ft. (30 m).
NOTE: The consistency of sea water, or chemicals used in a swim-
ming pool may impact the heart rate signal reception.
7. G
ENERAL OPERATION OF THE
HR
MONITOR
7.1 Buttons on the HR watch
1 START/STOP Starts and stops functions and adjusts values.
Press and holding accelerates the entry.
2
OPTION/SET Switches between the functions within one
menu and confirms settings.
3
MENU
Switches between the different menus.
4
/
Pressing quickly illuminates the display for
five seconds. Pressing and holding acti-
vates/ deactivates the acoustic alarm when
exiting the training zone.