Bluelab Dosetronic Solenoid Kit - Manual (Page 14)

10
Version S1.3 : 260511
Bluelab Dosetr
onic Solenoid Kit
Bluelab Corporation Limited
Po
w e r
pH Dosing system
Temperature
Conductivity
pH ATC Alarm
Power Input DC INPUT: 5V --- 3A
Temperature Power Out Temperature
Power In
pH
(lower or raise)
Nutrient B Nutrient A Power
24V AC
Steps
1. Plug main solenoid lead into Dosetronic case.
2. Each pair of connectors is labelled for identifi cation.
3. The main lead has three leads that branch from
it. Each lead has two plugs, attach both of these
to the top two connectors of each solenoid. There
is no connector for the bottom terminal (polarity
is not important).
4. Connect the solenoid power source
(24V AC) to the solenoid leads.
Run lead sets from the solenoids
around the back of the stock
solution tanks as pictured
2.6 Solenoid Connection
2
Attach eachv lead with two
plugs to solenoid
A
A