Bluelab Dosetronic Solenoid Kit - Manual (Page 16)

12
Version S1.3 : 260511
Bluelab Dosetr
onic Solenoid Kit
Bluelab Corporation Limited
2.8 Temperature Adjustment
The Dosetronic can control either air or
water temperature via an external heater/
cooler.
These sockets allow the Dosetronic to
switch the heater or cooler on and off.
The heater/cooler works at defined
intervals. These intervals can be
programmed in the “On” and “Off Times”
found in the Mode menu. Instructions for
this can be found on page 23 and 24.
Note: Do not connect the “Temperature
Power In” to a power source until you
have programmed the Dosetronic
Controller.
Temperature Power In
This socket provides external power for
the heater or cooler.
Temperature Power Out
This socket is where you plug in a heater
or cooler.
Temperature
Power In
Temperature
Power Out
Temperature
Power In
Temperature
Power Out
2
Or
Po w e r
pH Dosing system
Temperature
Conductivity
pH ATC Alarm
Power Input DC INPUT: 5V --- 3A
Temperature Power Out Temperature
Power In
Note: You must place temperature
probe in or near what you are
controlling