Bompani BO243EA/E - Manual (Page 24)

6
3. APPLIANCE OPERATION
When the control is fi rst turned on, the display shows the clock set at 12:00, which can be increased by one unit every minute. The
oven is off and the possible operations for unblocking it are: the “Clock setting” procedure or, in alternative, directly turning it on. The
detailed operations for setting the clock, the timer, duration, and end of cooking process are indicated in the relevant paragraphs that
follow. Through a single setting key, the oven cyclically enters into the display and modifi cation mode (shown on the fl ashing display),
in which the “+” and “-“ keys are activated to correct the value indicated on the display. This value is, however, accepted after 4 sec-
onds from the last time the key is pressed (the display stops fl ashing).
3.1. CLOCK SETTING
Scroll through the menu with the Timer Mode key until “hour” is displayed, and set it using the “+” and “-“ keys. The clock can only be
set with the oven in stand-by.
3.2. TURNING OVEN ON/OFF
Press and release the “O/I” key. “ON” will appear on the central display, the symbol lights up, as well as the light inside the oven. If
after a minute a cooking mode was not selected, the oven and the symbol turn off, and “OFF” will appear on the display. To turn the
oven off during cooking, press and release the 0/l key. With the key activated, it must be released at least 1” after being pressed.
3.3. TIMER
This function does not interact with loads, and it is always available regardless of the state the oven is in. Press the “Time” key, the
bell symbol lights up, and the display shows what is explained in paragraph 2.2. Set the desired value in minutes using the “+” and
“-“ keys, up to a maximum of 180 minutes. After 4 seconds without increasing or decreasing ,the information is accepted, and the bell
remains lit. Once the time set has lapsed, an acoustic signal is heard, and the bell symbol fl ashes. To stop both the acoustic signal
and the fl ashing symbol, just press any key; its associated function is normally not carried out (it is only needed to stop the signal).
3.4. SEMI-AUTOMATIC COOKING TIME FUNCTION
Turn the oven on, as indicated in paragraph 3.2. Pres and release the “Time” key, until “dur” appears. Set the time required for cooking
using the “+” and “-“ keys, up to a maximum of 180 minutes. Select a cooking function among those available, as indicated in paragraph
3.9: the oven will suggest a predetermined temperature. The temperature can be changed. After 4 seconds from the last time the key
was pressed, the oven turns on for the time set. After the time defi ned has ended, the oven enters the Cooking Ended mode.
3.5. SEMI-AUTOMATIC COOKING END FUNCTION
Turn on the oven as indicated in paragraph 3.2. Press the “Time” key until “End” appears. Use the “+” and “-“ to set the cooking end
time, which must occur within the next 23h59m. To enter the time, the same steps should be followed as those for the clock setting
(current time). After 4 seconds from the last time the key was pressed, the oven turns on for the time set. A cooking function among
those available can always be selected. The oven suggests a predetermined temperature. The temperature can be changed. Once
the time specifi ed has bee reached, the oven enters into the Cooking End mode
3.6. AUTOMATIC FUNCTION
Turn the oven on as indicated in paragraph 3.2. Press and release the “Time” key until “dur” appears. Set the cooking time required
using the “+” and “-“ keys, until a maximum of 180 minutes. Press the “Time” key again until “End” appears. Use the “+” and “-“ keys to
set the cooking end time, which must occur within the next 23h59m. After 4 seconds from the last time the key was pressed, the oven
enters the delayed start mode: it will then automatically turn on for the length of time specifi ed and will stop at the stop time specifi ed,
entering the Cooking end mode. Even during the delayed start phase, the temperature and the function are both displayed, and both
can be changed. All the oven loads are deactivated once the oven must start. The symbol will show the element selected, but will
maintain the light off symbol and the stopped fan symbol. The tangential fan runs according to the indications specifi ed in paragraph
0, while the oven light is separately illustrated in paragraph 3.13
3.7. COOKING END MODE
Once the timed cooking process has terminated, the oven turns off all the loads, and a triple intermittent acoustic signal of average
intensity is heard. The display temperature and functions turn off. The clock display shows the time, and the two “pot” and “auto”
symbols fl ash. To unblock the oven, just press any key among those positioned under the display: the acoustic signal stops, and the
oven is ready to receive new commands. It is possible to immediately select a new cooking function, or completely turn off the oven
by pressing the “O/I” .
Instructions GB