Bompani BO243EA/E - Manual (Page 33)

15
• if the appliance is supplied without a cable, use a type H05RR-F or H05V2V2-F cable of suitable gauge (see Fig. 2 – page 17);
The installer is responsible for making the electrical connection correctly and for compliance with safety regulations. The electrical
connection diagrams are provided in Fig. 2 – page 17.
IMPORTANT WARNING:
The manufacturer cannot be held responsible for any damage caused by failure to comply with the instructions provided and the
relevant regulations and standards.
7. GENERAL PRECAUTIONS
7.1. Oven Accessories
The accessories provided in the oven are:
1. The shelf, which supports the pans for cooking confectionery or roasts, or on which meat for grilling is placed directly.
2. The drip pan under the grill is used to collect juices, which drip from the food that is cooked directly on the grill. The drip pan can
also be used for cooking.
7.2. “Pull-Out Oven Runners” Kit
Some versions of the appliance are fi tted with telescopic runners.
They are extremely convenient when cooking, since they allow shelves to be pulled right out, and stopped in the fully extracted position.
This convenient aid allows foods to be checked with no risk of burns, and ensures more thorough cleaning.
The oven can be fi tted with a “Pull-Out Runner” kit on request.
This optional can be ordered from your dealer.
8. ASSISTANCE – DIAGNOSTIC MODE
When the oven is in the Power-up state (fl ashing clock), the test mode can be activated by simultaneously pressing the TEMPER+
and the EDITION+ keys for 5 seconds.
8.1. Phase 1 – Display Board
All the display segments are all turned on. If a key is pressed, the code associated to this key is temporarily displayed, to then return
to display all the segments. The automatic repetition is activated for keys equipped with this function.
If a key is not pressed for approx. 10 seconds, the oven passes to the next phase.
8.2. Phase 2 – Power Board
The clock display shows “8888” with the symbols fl ashing, while the display shows the temperature read by the oven probe. The
symbol is off. By pressing a key, the associated code is shown on the clock display.
The Double Cut relay is kept closed, and all the other relays are cyclically activated, one at a time. Once the last relay is reached, the
cycle starts over.
If a key is not pressed for approx. 10 seconds, the diagnostic phase is terminated and the oven returns to the Power-up phase.
9. MALFUNCTION SIGNALS
9.1. Detecting malfunctions
When a malfunction occurs, the control system begins to monitor this signal and considers it plausible only if it persists for more than
1 minute. If during this minute another malfunction presents itself, the system considers it plausible if it persists for more than 4 se-
conds.
When the malfunction is plausible, the system passes to the Malfunction display mode: the oven is off, all the loads are deactivated,
and the “Err” message appears, alternating with the type of malfunction detected:
“Shor” : oven probe in short circuit
“OPEN”: oven probe in open circuit and not connected
“ntc1” : thermal probe on Power board
During this phase, the malfunction signal can be “annulled” by pressing any key: if the malfunction is still present, everything returns
to the display mode after 1 minute.
If the malfunction is not autonomously resolved, the control continues to indicate “Err”, without any additional explanation.
If a probe malfunction occurs, the system reacts as if a temperature higher than 500°C has been reached.
Instructions GB