Compuprint SP40 - Manual (Page 28)

24
P P r r i i n n t t i i n n g g t t h h e e T T e e s s t t P P a a g g e e
The Self Test page is useful to test, if the printer has been correctly installed, and allows to see
the current parameter settings.
1. With the printer in the Setup Mode, insert a single sheet in A4 or Letter format.
2. The printer loads the sheet and stops.
3. Press the
ON LINE
key again.
The printer prints the Self-Test page. Check that the printout is correct. The following printout
example shows the Printer Setup default values.
Once the self-test is finished, the printer remains in Setup Mode.
S ELF T EST
SP40 :
Code Version Vx.x xxxxxxxx CharGen:xxxxxxxx ver. x.xx
CONFIGURATION SETUP
PROGRAM on interface AUTOFEED SIGNAL disabled
ERROR BUZZER enable SLCT-IN SIGNAL disabled
JOB BUZZER no beep IGNORE PE enabled
COPIES yes BUFFER CONTROL DTR+SRTS
LOW NOISE no ROBUST XON enabled
EDGE DETECTION Normal WORD LENGTH 8 bit
SAFE BOTTOM EDGE yes BAUD RATE 9600 bps
GET EDGE QUOTE 1/4” PARITY BIT none
PASSBOOK TYPE sw control STOP BIT 1
fixed thick
INTERFACE TYPE automatic
IBM FINANCIAL no
INPUT BUFFER 8 Kb PRINT HEAD LIFE xxxxx chars
RIBBON LIFE xxxxx chars