Compuprint SP40 - Manual (Page 41)

37
Setup Parameter Values Description
CR=LF+CR
LF=LF+CR
LF&CR=LF+CR
If the printer receives a CR code (CR), it performs a carriage return
followed by a line feed. If the printer receives a LF code (LF), it
performs a line feed.
If the printer receives a LF code (LF), it performs a line feed followed
by a carriage return. If the printer receives a CR code (CR), it only
performs a carriage return.
If the printer receives a LF code (LF) or a CR code (CR), it performs
both a line feed and a carriage return.
WRAP MODE truncate, autowrap The data exceeding the line length are truncated ( truncate) or
printed on the following line ( autowrap).
REFERENCE EDGE left, rigth Document reference on left or right, for software compatibility.
SLASHED ZERO no, yes Selects the printing character for zero, with a slash ( yes) or
without ( no).
EJECT ON FF no, yes Performs a form feed according to the selected page format ( no) or
ejects a cut sheet loaded into the printer ( yes).
RESET WITH EJECT no, yes When the printer receives a reset command, if this item is set to yes
the paper inserted in the printer is ejected. If the item is set to no the
printer performs only the reset command.
CUT SHEET EJECT on front, on rear Selects whether the cut sheet loaded into the printer is ejected
towards the front or the rear of the printer.