Cybex 751T Treadmill - Manual (Page 29)

Cybex 751T Treadmill Owner’s Manual
29
Testing the Treadmill Operation
Use the following instructions to test the full speed and incline range of the treadmill and to check the
belt for proper operation.
CAUTION: Serious injury or damage to machine can occur. To avoid injury or damage the
following procedure must be followed. During this procedure STAY OFF THE
RUNNING BELT! Stand with your feet on the two steps.
Cybex recommends that the treadmill be unplugged or the on/off (I/O) power switch turned off (O)
when it is not in use.
1. Without anyone on the treadmill, plug the power cord into a power outlet from a grounded,
dedicated circuit as described under Electrical Requirements in this chapter.
Ensure the power cord is not being pinched under the front of the treadmill.
2. Locate the on/off (I/O) power switch in the front motor cover of the treadmill. Toggle it to the on
position (I).
3. The control panel will light up and be in the Dormant Mode.
4. Press the Quick Start key. The treadmill begins a countdown “BELT START IN 3...2...1” and
sounds a tone for each count. After it reaches one (1), the treadmill gives a longer tone and
then begins accelerating the belt to reach 0.5 mph (0.8 kph).
5. The lower left display will show the incline then time and the lower right display will show the
actual speed.
6. Press and hold down the Speed + key until the treadmill reaches a speed of approximately 4
mph (6.4 kph), as indicated on the display.
7. Observe the belt to see that it is running properly; it should stay centered in the middle of the
deck. If you have problems with the running belt operation, see Running Belt Adjustments in
the Preventive Maintenance chapter.
8.
Run the treadmill through its full speed range. First press the Speed + key until the treadmill
reaches its highest speed. Then press the Speed - key until the treadmill is back to 0.5 mph
(0.8 kph).
9. As you press the Incline or Speed + - keys, the respective displays will show the actual
incline or speed.
10. When the treadmill reaches the set incline and speed, the displays will remain steadily
illuminated to indicate that the desired settings have been reached.
11. Run the treadmill through its full % grade range. Press the Incline key until the treadmill
reaches its highest grade (15%). Then press the Incline key until the treadmill reaches -3%
grade.
12. Press the Stop key to stop the running belt, end the workout review and return the display to
Dormant Mode.