Daktronics AB-1600-1.5,2.5 - Manual (Page 10)

Introduction 1-2
of digits and the letter preceding them. In the example below, the drawing would be referred to as
Drawing A-114667.
All references to drawing numbers, appendices, figures or other manuals are presented in bold
typeface, as shown below.
“Refer to Drawing A-114667 in Appendix B for the location of the Venus 1500 controller.”
In addition, any drawings referenced within a particular sub-section are listed at the beginning of that
sub-section in the following manner:
Reference Drawing:
Shop Drawing, 16 High 2 ½” Small Matrix .............................................Drawing A-114667
Referenced drawings are found in Appendix B.
Daktronics identifies manuals by the ED number located on the cover page of each manual. For
example, this manual would be referred to as ED-11943.
Please list the model number, display serial number and the date this display became operational in the
blanks provided on the front page of this manual. The serial number and model numbers can be found
on the ID label, located on the front of the display on the right end. This label will look similar to the
one shown in Figure 2. When calling Daktronics Customer Service, please have this information
available to ensure that your request is serviced as quickly as possible.
Daktronics builds displays for long life and require little maintenance. However, from time to time,
certain display components will need replacing. The Replacement Parts Lists in Sections 4.21 and
4.22 provide the names and part numbers of components that may need to be ordered during the life of
this display.
Following the Replacement Parts List in Section 4 is the Exchange/Replacement Procedure in
Section 4.23. Refer to these instructions if any display component needs to be replaced or repaired.
Figure 1: Drawing Label
Figure 2: Display ID Label