Daktronics Gen VI Radio - Manual (Page 10)

4 Setting Radio Channels
2.2 Power-Up Sequence & LED Indicators
The sections below outline the power-up sequence of both the client (scoreboard) and server
(console) sides of the radio system under normal operating conditions. LED indicator
locations and descriptions are also provided.
Server (Console)
1. Power ON – the POWER indicator (green LED) on rear of console illuminates.
2. While the console displays the software version on the LCD, the radio detects if it is
connected to the console.
a. Once a console connection is detected, the radio boots up in Server Mode.
b. The STATUS indicator (amber LED) on the back of the console illuminates.
3. The controller will ask to Resume Game? – select one of the following choices:
a. [Yes] - The console immediately begins sending information over the radio link,
using the channel it was set to when last shut off.
b. [No]
1) After entering or accepting the Sport Code, the console checks if the radio is
installed. If detected, the console displays the current Broadcast and Channel
numbers.
2) Accepting the listed values results in no changes to the radio, and the console
begins sending information over the radio link.
3) Changing the listed values updates the settings, and the console begins
sending data over the radio link on the new channel.
Refer to Section 2.3 for information about changing the radio settings in the console.
Figure 3 shows the LED indicators on the radio transmitter, located on the rear of the console.
 STATUS (amber LED) –
Should always be ON when
installed in a console;
signifies that the radio is
operating in Server Mode
 DATA (red LED) –
Active when data is received
from the console and passed
to the radio transmitter
 POWER (green LED) –
Illuminates when power is
applied to the transmitter
Figure 3: Radio Transmitter (on Rear of Console)