Daktronics Gen VI Radio - Manual (Page 13)

Setting Radio Channels 7
Multiple Controller System with Single Broadcast Group
In a multiple controller system with a single broadcast group (Figure 6), there may be one
console for each scoreboard and/or one master controller that can run every scoreboard at
one time or take control of a specific scoreboard. An example of this type of system is a
softball complex with individual scoreboards on several different fields.
Multiple controller systems typically use Broadcast 1 and Channel 1 for the first controller
and Channels 2–8 for all remaining controllers. All radio receivers in the system must be set
to Broadcast 1 (BCAST 1).
Display Action
The LCD will toggle between
these 2 screens.
The LCD shows the current radio settings along with a prompt
to accept or modify these values.
If the radio settings are correct press <ENTER>.
If these values are incorrect press <CLEAR>, and the LCD at
bottom left is shown, allowing edit of the channel or broadcast
group setting.
Broadcast Group Setting
1 Use this setting for all multiple controllers with single
broadcast group setups. Use the number keys to edit
this value and press <ENTER> to accept. The asterisk
will move to the channel setting.
Channel Setting
1-8 Edit the channel number to the desired value and press
<ENTER> to accept. The CHAN switch on the receiver
must match this value.
Figure 6: Single Broadcast Group
BCAST 1, CHAN 1
BCAST 1,
CHAN 01
BCAST 1, CHAN 8
BCAST 1,
CHAN 08
BCAST 0,
CHAN 00
to control all at once
Or
BCAST 1,
CHAN 01 –08
to control a specific
scoreboard
ENTER TO ACCEPT
CLEAR TO MODI FY
RADI O SETTI NGS
BCAST X CHAN YY
BCAST GROUP 1*
RADI O CHAN 01