Daktronics Remote Control System RC-100 - Manual (Page 11)

RC-100 System Overview 5
Section 2: RC-100 System Overview
The RC-100 system allows wireless control of multiple display
applications. This system is made up of two distinct hardware
components: the RC-100 wireless handheld controller, and the RC-
100 wireless Base Station.
The RC-100 wireless handheld controller (Figure 2) includes a 4x4
keypad and a 97x32 liquid crystal display (LCD). The RC-100
wireless handheld controller is used to enter information to be
displayed on a display. The handheld operates using a 900 MHz
radio with internal antenna and comes with a rechargeable Ni-MH
(Nickel Metal Hydride) 2000 mAh battery which provides 8-10
hours of operation.
The RC-100 wireless Base Station processes information received
from the wireless handheld controllers and sends this information
to the display or another external controller. Based on the
application, an RC-100 wireless receiver may be mounted outside
in an external enclosure (Figure 3), or mounted inside in a tabletop
enclosure (Figure 4).
Important Installation Range Considerations
The wireless Base Station must be located at least 10' (3 m) from the wireless handheld controller and
no more than 500' (152 m) away. If the wireless handheld is used outside this range, the wireless
handheld signal may drop out. Ideally, the handheld controller should have a clear line-of-sight to
the Base Station antenna. Make sure the Base Station antenna is pointed straight up for best reception
(it should look like a capital “L” when viewed from the side).
Figure 2:
RC-100 Wireless
Handheld Controller
Figure 3:
RC-100 Outdoor Enclosure Figure 4: RC-100 Base Station (Tabletop Enclosure)