Daktronics Remote Control System RC-100 - Manual (Page 24)

18 RC-100 Handheld Controller
Signal Strength Indicator
Once a connection has been made, the top line of the LCD will
show the signal strength (Figure 13). This indicator shows the
approximate signal strength of the network connection. Each
successive bar indicates an additional level of signal strength
between the handheld and Base Station. When no bars or 1 bar
is visible, the connection to the wireless network is likely to be limited, and the console may
occasionally fail to respond. To improve signal strength, move within range of the Base
Station, and remove any obstacles located between the Base Station and handheld controller
if possible. For more information refer to Section 2.
4.5 Common Keys
Several keys on the default keypad layout are common to multiple wireless handheld
applications. These keys are noted in Figure 14. For a description of the function of keys for a
particular application, refer to the application-specific sections of this manual.
# Key Function
1 CONNECT
This key is used to connect to a wireless Base Station.
Refer to Section
‎4.4 for more information.
Pressing <ALT> followed by <CONNECT> when a connection
is made to a wireless Base Station will show Base Station
synchronization and revision information. Refer to Section
‎9.2
for more information.
2 Numbers
These keys are used for numeric entry functions. While a
particular key may normally be assigned to application-specific
functions, in an Edit routine, they are also used to enter the
number shown in the corner of the key.
Figure 13: Signal Strength
Figure 14: Common RC-100 Keys
1
2
3
4 5