Daktronics Remote Control System RC-100 - Manual (Page 35)

Gas Price Operation 29
Section 6: Gas Price Operation
Insert: LL-2617
The insert drawing is located in Appendix A. If an insert is lost or damaged, a copy of the insert
drawing can be used until a replacement arrives. Refer Section ‎4.1 for information on starting up the
handheld controller and Section ‎5.2 for additional DataMaster application keys.
6.1 Gas Price Controller Operation
Display Action
After entering the Gas Price mode, the LCD will toggle
between the two screens shown at left.
Press the up or down arrow keys <

> to scroll through
the current setting for any of the lines on the display.
Press <ENTER> to modify any of the line settings.
L = current line
D = current dollar value
CC = current cent value
Use the number pad to edit the price value for the line.
Press <ENTER> to accept the new value or press
<CLEAR> to cancel the changes.
To send the updated values to the display, press
<DISPLAY SEQUENCE>. Refer to Section
‎5.2.
6.2 International Gas Price Display Operation
International gas price displays must be operated in Rate Display mode. To switch to Rate
Display mode:
1. Press <ALT> followed by <NEW CODE>.
2. Press <ENTER>.
3. Use the arrow keys <↑↓> to select RATE DISPLAY and then press <ENTER>.
Now a four-digit price can be entered. The fourth number represents the digit in the 1/10 of a
cent position.
LI NE PRI CE
1 } $ O.OO 9/1O
<EDI T> TO MODI FY
1 } $ O.OO 9/1O
EDI T LI NE L
$ D.CC* 9/1O }
SEQUENCE SENT
DI SPLAY RESPONSE