DFI Q7-951 - Manual (Page 26)

26
2
Hardware Installation
I/O Connectors
S/PDIF Connector
The S/PDIF connector is used to connect external S/PDIF ports. Your S/PDIF
ports may be mounted on a card-edge bracket. Install the card-edge bracket to
an available slot at the rear of the system chassis then connect the audio cable
to the S/PDIF connector. Make sure pin 1 of the audio cable is aligned with pin 1
of the connector.
5 1
+5V
Key
SPDIF out
Ground
SPDIF in