DFI Q7-951 - Manual (Page 45)

45
2
Hardware Installation
LPC connector
The Low Pin Count Interface was defi ned by Intel ® Corporation to facilitate the in-
dustry’s transition towards legacy free systems. It allows the integration of low-
bandwidth legacy I/O components within the system, which are typically provided
by a Super I/O controller. Furthermore, it can be used to interface fi rmware hubs,
Trusted Platform Module (TPM) devices and embedded controller solutions. Data
transfer on the LPC bus is implemented over a 4 bit serialized data interface, which
uses a 33MHz LPC bus clock. For more information about LPC bus refer to the Intel
®
Low Pin Count Interface Specifi cation Revision 1.1’.
VCC3
LAD0
LAD1
GND LAD3
RST#
FRAME#
CLK
1
9
2
LAD2