Digi-Star EZ 320 - Manual (Page 15)

MODEL 320 - System Operation:
13
Step 6) The scale will display the message Method 2:
"STORED" indicating that the ingredient has
been saved into non-volatile memory.
Step 7) Continue steps 4 through 6 until all
ingredients have been entered.
Step 8) Press [RECIPE#] to complete the
recipe. The scale will now calculate and
display the "TOTAL" value of the recipe.
Step 9) Repeat steps 1 through 8 until all
recipes have been entered.
Step 10) Press [PROGRAM] to exit the
"recipe programming mode" and enter the
weighing modes.
To Edit a Recipe:
To enter the program mode press and hold the
[PROGRAM] key and then press the [ON]
key. Continue holding both keys until the
indicator beeps and the scale displays the
message "PROGRM". The "recipe program
annunciator" will be flashing.
The scale then displays the first formula
number programmed "REC-XX". Use one of
Step 2) Then use the numeric keypad to select
the following methods to select the recipe to the recipe number. Then press [RECIPE #] to
edit: enter the recipe number.
Method 1: Step 3) The EZ 320 will then display a
Step 1) Press [RECIPE#] until 1 - Pounds per Animal.
the desired recipe number 2 - Percentage of Total Load.
is displayed. 3 - Ingredient in Pounds.
Step 2) Then press [INGR#] will be displayed "YY:XXXX".
to edit this recipe. Now go
to Step 3.
The first two digits, "YY" represent the ingre-
Step 1) Press [CLEAR].
message indicating the "entry method" to be
used:
Step 4) The ingredient number and amount
dient number. The last four digits, " XXXX"
represent the amount for this ingredient.