Digi-Star EZ 320 - Manual (Page 16)

MODEL 320 - System Operation:
14
In this example, ingredient number "05" is
shown with an ingredient amount of "500".
Step 5) Pressing [INGR.#] will advance the
scale to the next ingredient of the recipe.
Press [INGR.#] until the desired ingredient is
displayed.
Step 6) Press [CLEAR] and then use the
numeric keypad to select the four (4) digit
ingredient value. Press [LOAD/UNLOAD] to
enter the value.
Step 7) The scale will display the message
"STORED" indicating that the ingredient has
been saved into non-volatile memory. Non-
volatile memory is a special type of memory
that allows the power to be removed from the
scale without losing any of the recipes.
Step 8) Continue steps 5 through 8 until the
desired changes have been made.
Step 9) Press [RECIPE#] to complete the
recipe. The scale will now calculate and
display the "TOTAL" value of the recipe.
Step 10) Press [PROGRAM] to exit the
"recipe programming mode" and enter the
weighing modes.
NOTE: Ingredient amounts can be changed,
but to add ingredients to a recipe, first erase
that recipe and then re-program the recipe.
To Erase a Recipe:
To enter the program mode press and hold the
[PROGRAM] key and then press the [ON]
key.
Continue holding both keys until the indicator
beeps and the scale displays the message
"PROGRM". The "recipe program
annunciator" will be flashing.
The scale then displays the first formula
number programmed
"REC-XX". Use one of
the following methods to select the recipe to
erase:
Method 1:
Step 1) Press [RECIPE#] until
the desired recipe number is
displayed, then go to Step 3.
Method 2:
Step 1) Press [CLEAR].