Exacq exacqVision Web Service User Manual User Manual
Page 6
www.e
x
acq.com
Page 6 of 24
6/11/2015
2
INSTALLING AND CONFIGURING THE EXACQVISION WEB SERVICE
The exacqVision Web Service must be enabled on a server before you can use it. To install exacqVision Web
Service, download it from
Run the setup file while logged in as the
administrator of the server. Follow the simple onscreen instructions to install Web Service.
To start the Web Service, go to Start, Programs, exacqVision Web Service, and then Start exacqVision Web Service.
It is recommended that you select Set exacqVision Web Service to Start Automatically (using the same path on the
Start menu) in case of a power outage and unexpected system restart.
To configure web service, you must open the Web Service browser on the localhost and enter the system
hostname as the address. Click the Web Service Configuration link at the bottom-right corner of the page.
Three sections are available on the configuration page: Servers, Basic Configuration, and Administration
Configuration, as described in the following sections.
NOTE: If Localhost Restriction is disabled on the Administration Configuration page, the Web Service Configuration
link is enabled on all systems that can connect to the Web Service. See the Administration Configuration section
for details about Localhost Restriction.