Flowserve PMV D3 Digital Positioner - Manual (Page 42)

42
• Tighten the screws F, on the cam assembly.
Do not tighten the screws to hard. The cams
should be able to move in relation to each
other.
• Install the inner cover with the two screws,
G.
• Connect the wiring for the transmitter feed-
back on the terminal block, according to the
drawing on next page.
• Adjust the position where the switches/
sensors should be affected, by turning the
cams with a screwdriver.
• Tighten the cam assembly screws F when
the cams are correctly adjusted.
• Install the indicator and cover.
To calibrate the feedback transmitter, see
drawing on next page.
F
G
F