Basic settings – Flowserve URB 1 User Manual
Page 40
Advertising
40
Basic Settings
– continued –
Adjusting sensitivity of response
Press button twice briefly to activate
the line editing mode.
Use buttons and to toggle between
the two settings.
The split-screen window shows which
GESTRA bus devices can be indicated:
■
High-level limiter NRS 1-41
■
Low-level limiter NRS 1-40
■
Level switch NRS 1-42
■
Conductivity controller LRR 1-40
Before commissioning the installation
adjust the response sensitivity of the NRS
1-42.
The response sensitivities of the high-
level and low-level limiters are factory
set and cannot be changed.
Press button twice briefly to select
either of the following two response
sensitivities:
■
0.5
µ
S/cm
■
10
µ
S/cm
flashing
twice briefly
twice briefly
Advertising