JLCooper MCS3 SP USB for OSX User Manual
Page 10
Some key/modifier combinations may be intercepted by the operating system before
they reach the Inspector window. If this happens, just type the key without any
modifiers, then click on the appropriate checkboxes to add the desired modifiers.
To add more keystrokes to the sequence, click on the Next button and repeat the above
procedure. You can move forwards or backwards in the sequence with the Next and
Previous buttons. The Delete Keystroke button will remove the currently displayed
keystroke from the sequence.
If Repeat while pressed is checked, the keystroke (or sequence) will repeat as long as
the MCS3 SP control is held down. The speed of the repeat is controlled by the Repeat/
Typing Speed slider. This slider also determines how much time there is between
keystrokes if the sequence is more than one keystroke.
If the key sequence in the example below was assigned to the STOP button, pressing
and holding STOP would be the equivalent of repeatedly typing the word “mark” until
STOP was released.
MCS3 SP USB Software
8