Denso BHT-7000 - Manual (Page 56)

40
Selecting "2: DOWNLOAD" on the SYSTEM MENU
calls up the screen shown at left.
1 FILE : Downloads a user program
file or data file to the user
area of the BHT-7000.
2 HT<-->HT COPY : Downloads all of the files,
system parameters, and cal-
endar clock data stored in
the connected BHT-7000.
This function enables copy-
ing between the BHT-7000s.
For the preparation to be
made preceding the start of
this function, refer to NOTE
below.
Select a desired item by using the numerical keys
or
* and * keys, and the selected item be-
comes highlighted. Then press the ENT key.
To return to the SYSTEM MENU, press the C key.
[ 2 ] Downloading
If you download a file having the same name as one already used in the user area of
the target memory in the BHT-7000, the newly downloaded file replaces the old
one.
NOTE Preparation for Copying between the BHTs
Before downloading to the BHT-7000 from another BHT-7000, make the fol-
lowing preparation:
• At each BHT-7000, set the interface port. The default is an optical interface
(Optical).
Interface setting procedure: Starting on the SYSTEM MENU, select "4:SET
SYSTEM," "5:COMMUNICATION," and "3:COM PORT." On the SET COM
DEFAULT PORT screen, select the optical interface (Optical) or direct-con-
nect interface (Connector) of "2:SYSTEM MODE."
• When using the direct-connect interface, pull out the connector cover on
each BHT-7000 to expose the direct-connect interface port. Connect the
BHT-7000s via those ports with the direct-connect interface cable (having 3-
pole mini stereo plugs). For the details about the cable, refer to Chapter 3,
Section 3.1.
• On the uploading BHT-7000, run System Mode and select "3:UPLOAD" and
"3:HT<-->HT COPY."
DOWNLOAD
1:FILE
2:HT<-->HT COPY
* For BHT-7000s having a 26-key pad, use F5 , F6 , F7 and F8 keys instead of , ,
, and keys, respectively